336-789-2866 

​276-755-2606

102 West Lebanon Street Mount Airy, NC 27030

VCT ​STRIP/WAX FLOORS


​Walk into virtually any commercial facility today and odds are pretty good the floor under your feet is vinyl composition tile (VCT). VCT has proven to be a highly popular flooring choice because of its durability and ease of maintenance. But in order to sustain its durability and be reasonably scratch resistant, VCT needs to be cleaned regularly and maintained properly. Additionally, VCT requires protection, and a polyacrylate floor finish creates a “renewable, repairable, restorable” wear layer that can be used to maintain the beauty and clean, shiny appearance that people want to see in a floor. 


Maintain Floor Appearance While Minimizing Cost :


Simply put, sticking to a regular maintenance schedule and using the right cleaning products are the best way to maintain the look of any VCT floor. Below are tips for maintaining VCT. 

Proper matting: Use walk-off mats at all entryways to help keep floors clean and dry longer; however, it is vital that these mats be cleaned regularly.
Daily cleaning regimen: Involves sweeping and dust mopping dirt and soil off VCT surfaces, a crucial step to prevent damage to the tile finish. Then, damp mop or auto-scrub floors using a neutral-impact cleaner to remove particulate left behind. Once clean, the entire floor should be rinsed with clean water and then allowed to dry thoroughly.
Recoating: Depending on VCT maintenance or the amount of foot traffic at a particular facility, it is good practice to periodically recoat the finish. Following a deep scrub of the VCT to remove soil build-up, reapply a high-quality commercial floor polish. Failing to ensure that there are three-to-five layers of protective finish means risking potential damage to the tiles from embedded soil that can eventually result in poor appearance, and ultimately the need to replace the flooring.  
Routine maintenance: It is important to routinely strip off the wax that has built-up from repeated maintenance in order to apply a fresh finish. The VCT should be scrubbed with an effective stripping agent, but note that most flooring manufacturers recommend not using an aggressive stripper on VCT that is less than two years old, as it may weaken the adhesive bond. After the stripping solution has been applied, it should be carefully removed with a wet vac or auto-scrubber vac. Then, the floor should be rinsed with clean water and allowed to dry before three-to-five coats of floor polish are applied to complete the process.